railroad.wikisort.org - Train

The Denver and Rio Grande Western K-28 is a class of ten 3 ft (914 mm) gauge narrow gauge 2-8-2 "Mikado" type steam locomotives built in 1923 by the Schenectady Locomotive Works of the American Locomotive Company (ALCO) for the Denver & Rio Grande Railroad. They were the first new narrow gauge locomotives ordered by the railroad since 1903.[1] They initially comprised class E-4-148-S, but were reclassified K-28 in 1924 when the railroad reorganized into the Denver & Rio Grande Western Railroad.[3]

Denver & Rio Grande Western K-28 Class
D&RGW K-28 No. 473 at Silverton, Colorado
Type and origin References:[1][2][3] Power type Steam Builder American Locomotive Company (ALCO) Build date 1923 Total produced 10
Specifications Configuration: ​  • Whyte 2-8-2  • UIC 1′D1′ h Gauge 3 ft (914 mm) Driver dia. 44 in (1,118 mm) Adhesive weight 113,500 lb (51.5 t) Loco weight As built:140,000 lb (63.5 t)[1] Later:156,000 lb (70.8 t) Tender weight 98,500 lb (44.7 t) Fuel type Coal (No. 473 and 476 converted to oil) Fuel capacity 16,000 lb (7.3 t) Water cap. 5,000 US gal (19,000 L) Firebox:  • Firegrate area 30.17 sq ft (2.8 m2) Boiler pressure 200 lbf/in2 (1.38 MPa) Heating surface:  • Firebox 102 sq ft (9.5 m2) Superheater Type A Cylinders Two, outside Cylinder size 18 in × 22 in (457 mm × 559 mm) Valve gear Walschaerts Valve type 11-inch (279 mm) piston valves Loco brake Straight air Train brakes No. 6 E-T
Performance figures Tractive effort 27,540 lbf (123 kN) Factor of adh. 4.12
Career Operators Denver and Rio Grande (D&RG) Denver and Rio Grande Western (D&RGW) White Pass and Yukon (WP&Y) Durango and Silverton (D&SNG) Class D&RG: 140 D&RGW: K-28 Numbers 470–479 Nicknames Sports Model Locale Colorado, New Mexico & Alaska Preserved Three (Nos. 473, 476 and 478) preserved on D&SNG, seven scrapped after WW2 Restored No. 473; 1981 No. 476; 1981 (1st restoration), February 2018 (2nd restoration) No. 478; 1981 Disposition Nos. 473 and 476 operational and No. 478 awaiting overhaul

Design

The chassis is of outside-frame design with the drive wheels placed between the two main frames and the steam cylinders and running gear (cranks, counterweights, rods and valve gear) to the outside. This general arrangement was also used on the earlier class K-27 and later class K-36 and K-37 engines.

Operations

Among other duties, they were tasked with hauling the express passenger trains over the D&RGW's narrow gauge lines, such as the San Juan from Alamosa to Durango, the Shavano from Salida to Gunnison and The Silverton from Durango to Silverton. The K-28s also operated on the Chili Line from Antonito to Santa Fe until that route was closed in 1941.

White Pass & Yukon

During World War II, seven members of the class were purchased by the US Army for use on the White Pass and Yukon Route in Alaska and the Yukon where they were renumbered USA 250 to USA 256. But they did not fare well in the bitter Yukon winters. In particular, the unusual, extended counterweights on the driving wheel axles made them liable to ride up on trackside ice, and as a result, lifting the engine off the rails. All seven were withdrawn from service in 1944 and were barged to Seattle in 1946 for scrapping.

The K-28s today

The three locos which remained with the D&RGW, numbers 473, 476 and 478, were assigned to the Durango – Silverton tourist trains from the 1950s onwards. The Durango & Silverton inherited these when it took over the Silverton Branch in 1981.[2] As of February 13, 2018, all three locomotives are operational. However, as of February 2020, number 473 is currently undergoing conversion from burning coal to burning oil. As of July 2021, the conversion to oil has been completed and the locomotive is currently in service. Number 478 is currently awaiting a future overhaul

Due to their smaller size, these engines are often used by the Durango & Silverton for shorter trains, usually the first or last on the schedule, and also for helper service or sectioned trains. Despite being slightly smaller, a little older and less powerful than the K-36s, the engine crews tend to favor a trip on these engines because the design ALCO used was superior in balance and servicing. Firing can be tricky when the engine is working hard, as the clamshell-style firedoors tend to pull into the backhead of the boiler due to the draft, and if any flues in the boiler are leaking, the loss of draft on the fire is much harder to work around than on the K-36 locomotives. Firing while the engine is working hard is done with a large "heel" pattern, generally with as little coal on the flue sheet as possible, and gradually sloping the fire bed towards the door sheet to the height or higher than the firedoors. This results in the draft being forced through the fire bed in the thinner areas towards the flue sheet, which usually is hindered by the lack of draft between the grates and the arch brick. New firemen sometimes have a hard time learning this because there are fewer training hours available on the K-28 class locomotives compared to the railroad's usual K-36 workhorses which have a larger firebox and are more forgiving of poor technique.

These locomotives are popular subjects for model railroaders and high quality scale models in HOn3 and On3 scales have been produced by several manufacturers since the 1950s.

Variants

The Oahu Railway and Land Company in Hawaii was impressed with the K-28 and ordered four locomotives of the same design which were delivered in 1925 and 1926. These were identical in specification but oil-fired and with minor differences in fittings (slightly shorter tender with an oil tank in place of the coal bunker, smokebox front, air compressor location, headlamp, etc.)[4]

Roster[3]

D&RGW Number	WP&Y Number	Builder's Number	Disposition
470	250	64981	Entered service at White Pass and Yukon Route on December 8, 1942. Scrapped.
471	251	64982	Entered service at White Pass and Yukon Route on November 28, 1942. Scrapped.
472	252	64983	Entered service at White Pass and Yukon Route on January 14, 1943. Scrapped.
473	N/A	64984	Retired in 1967. To D&SNG in March 1981. Restored to operating condition in 1981. Operational. Underwent conversion from coal-burning to oil-burning. returned to service May 2021.
474	253	64985	Entered service at White Pass and Yukon Route on February 28, 1943. Fell off barge into bay at Haines, Alaska, hence delay of service. Was the only K-28 to not be fitted with steam heat and signal lines for passenger service. Scrapped.
475	254	64986	Entered service at White Pass and Yukon Route on December 15, 1942. Scrapped.
476	N/A	64987	To D&SNG in March 1981. Restored to operating condition in 1981. Taken out of service in September 1999. Placed on display at the D&SNG Museum from 1999-2016. Rebuilt between 2016-2018. Converted to oil as of June 2022. Operational.
477	255	64988	Entered service at White Pass and Yukon Route on December 19, 1942. Scrapped.
478	N/A	64989	To D&SNG in March 1981. Restored to operating condition in 1981. Almost swapped with C&TSRR K-36 No. 483 in 2015. Taken out of service in late 2016. Currently on display in the D&SNG Museum. Awaiting a future overhaul.
479	256	64990	Entered service at White Pass and Yukon Route on January 10, 1943. Scrapped.

References

---